Smoke alarm false alarm caused by construction dust, Crested Butte CO
Heads up: This post was detected from real-time dispatch audio. Information may be incomplete, and the situation may evolve. Always verify using official agency releases.
Fire & ArsonFire units responded to a smoke alarm activation near Bear Scratch Lane in Mount Crested Butte. The alarm company reported the alarm but then canceled the call. Fire crews found the alarm was triggered by dust from construction work and stood down.
Audio|Heard on: Gunnison County Public Safety
Listen to dispatch call
00:59
Transcript:
00:00
Cresbyte Fire, Cresbyte UMS, respond to near Bear Scratch Lane, for a smoke alarm called in by the alarm company.
00:07
They did receive a keyed-in cancellation but cannot reach a key holder.
00:12
Cresbyte Fire, Cresbyte, respond to near Bear Scratch Lane, Mount Crested Butte for a smoke alarm called in by the alarm company who said they received a keyed-in cancellation but cannot reach any keyholder on site.
00:25
All units can move to Incident 1, 0755.
00:28
4-9.
00:31
I'm gonna roll till 105-air's crest line.
00:35
3057.
00:46
If you could advise, fire to stand down,
00:49
they're just doing some work on the house and the dust up is not far off.
00:56
It sounds like they are not going to respond.
00:58
Thank you. 0.802.
Disclaimer:
This transcript was automatically generated and may contain inaccuracies. Please verify the information independently.
Location mentioned:
Bear Scratch Ln, Crested Butte, CO 81224
This shows a Google Street View of the area near the location, which might not be the exact address.
Correct
Incorrect
Not all dispatch calls become confirmed incidents. This reflects early radio traffic only. Treat with caution.
