False fire alarm at nursing home on Weaver Boulevard, Weaverville NC
Heads up: This post was detected from real-time dispatch audio. Information may be incomplete, and the situation may evolve. Always verify using official agency releases.
Fire & ArsonFire units responded to a fire alarm at a nursing home near Weaver Boulevard. Upon arrival, no fire was found. The alarm was caused by a faulty smoke detector and the system was reset.
Audio|Heard on: Buncombe County Fire and EMS
Listen to dispatch call
01:34
Transcript:
00:00
State, fire alarm activation, near Weaver Boulevard.
00:03
Station 8, fire alarm activation, near Weaver Boulevard.
00:10
Station 8, fire alarm activation, near Weaver Boulevard.
00:14
Clinton Street and Fairfield Approach, Travel, Weir, Cross Street, Failed Fire, Dispatch, (number withheld).
00:23
DEN8, clear response.
00:24
Toadney.
00:29
Clatterate.
00:33
Communication is a new agency is going to be on the scene.
00:35
I have a large nursing home facility with nothing showing from two sides.
00:40
We'll be offered an investigation.
00:41
Isn't 82 a house command.
00:44
We'll be out on the scene of a large nursing home facility has shown from two sides.
00:48
We're about to investigate and have command at (number withheld).
00:51
The latter rates arriving.
00:56
B-level-1 staging on the Charlie side.
00:59
That light rate deriving level one on the far away side.
01:06
Thirteen clear, goodly.
01:10
You catchers from command.
01:13
You catchers from command.
01:29
It's showing a faulty smoke over.
01:31
We're attempting to reset the system right now.
Disclaimer:
This transcript was automatically generated and may contain inaccuracies. Please verify the information independently.
Location mentioned:
Weaver Blvd, Weaverville, NC 28787
This shows a Google Street View of the area near the location, which might not be the exact address.
Correct
Incorrect
Not all dispatch calls become confirmed incidents. This reflects early radio traffic only. Treat with caution.
